ADHESIVES - APPLICATORS 13

We offer quick-drying glues: Bostik, Gutermann or slow-drying glues: Wika, Hi-tack, Chrisanne Jewel Glue and Chrisanne Crystal Glue.

Waterproof glue: Bostik, Gutermann

You need to prepare an applicator with wax, scatter the stones on a saucer. Apply glue to the material: dots or lines depending on the pattern. With the tip of the applicator with wax, take a stone (which is lying flat side down), place it on the glue and press. The stone will stick. Press the stone with the other side of the stick so that the glue "pours" over the edges of the stone. Leave to dry. After gluing with Wika, Chrisanne Clover glue, you can iron the glued stones on the left side with an iron. IMPORTANT! Do not glue with your fingers or tweezers.

A wax applicator or Hotfix electric applicator should be used.

 How to glue with an applicator.

Choose the right size of the applicator tip for the size of the zirconia. Screw it in only when the applicator is cold. Flat tips are used when there is no zirconia that fits the size.

Put the plug into the socket and turn it on. Leave it for about 2 minutes.

1. Gently place the applicator on the zirconia lying flat side down and lift it. The zirconia will enter the recess of the tip. Do not press hard, because the zirconia may stick to the surface.

2. After about 5 seconds, depending on the size, the glue on the zirconia will start to be wet and shiny. Then the zirconia is ready to glue.

3. Lightly press the applicator to the surface being glued at a 90° angle and lift it. If the zirconia gets stuck in the tip, use a pin and press it to the surface through the gap and lift the applicator.

4. If the zirconia does not stick properly, heat it up again with the applicator and repeat the gluing.

5. Flat tips can be used to "improve" the gluing process